Juniper QFX10016 Hardware Manual page 229

Copyright © 2017, Juniper Networks, Inc.
seated in the slot. Ensure the power supply faceplate is flush with any adjacent power
supply faceplates or power supply cover panels (see
Push the captive screw into the power supply faceplate. Ensure that the screw is
16.
seated inside the corresponding hole on the faceplate.
Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver,
17.
number 1. When the screw is completely tight, the latch locks into the switch chassis.
Chapter 17: Replacing Power Supplies
Figure 106 on page 206).
205