Removing A Qfx10000 Ac Power Supply; Figure 95: Power Cord And Retainer Clip - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
Related
Documentation

Removing a QFX10000 AC Power Supply

194

Figure 95: Power Cord and Retainer Clip

1— Enable switch for INP1
WARNING: Ensure that the power cords do not block access to switch
components or drape where people can trip on them.
If the AC power source outlets have a power switch, set them to the on (
16.
Move the enable switches for input 1 and input 2 to the
17.
Verify that the and
18. INP1
steadily.
Press the power switch to the on (
19.
Removing a QFX10000 AC Power Supply on page 194
Connecting AC Power to a QFX10000 on page 165
Calculating Power Requirements for a QFX10008
Calculating Power Requirements for a QFX10016 Switch on page 114
QFX10000 Field-Replaceable Units on page 20
QFX10000 AC Power Supply on page 43
The AC power supply in a QFX10008 and QFX10016 switch chassis is a hot-removable
and hot-insertable field-replaceable unit (FRU). You remove AC power supplies from
the rear of the chassis.
2— Enable switch for
LEDs on the power supply faceplate are lit and are on
INP2
) position.
|
INP2
) position.
|
position.
ON
Copyright © 2017, Juniper Networks, Inc.