Juniper QFX10016 Hardware Manual page 303

Copyright © 2017, Juniper Networks, Inc.
Chapter 24: Contacting Customer Support and Returning the Chassis or Components
Leave components that came installed in the chassis in the chassis, such as the Control
Boards or power supplies.
Move the wooden pallet and packing material to a staging area as close to the switch
5.
as possible. Make sure there is enough space to move the chassis from the rack to
the wooden pallet.
Position a mechanical lift under the device. If a mechanical lift is not available, have
6.
three people support the weight of the switch while another person uses the
screwdriver to remove the front mounting screws that attach the chassis mounting
brackets to the rack. For QFX10008 removal, see Removing a QFX10008 From a 4-Post
Rack Using a Mechanical Lift or Manually Removing a QFX10008 from a 4-Post Rack.
For QFX10016 removal, see
Mechanical Lift" on page
Remove the switch from the rack (see Chassis Lifting Guidelines) and place the switch
7.
on the shipping pallet. Position the switch on the pallet so that the front of the switch
is facing the silkscreened "front" mark on the pallet. The pallet also has crop marks
to guide you in positioning the chassis
Use the 13/32-in. or 10-mm open-end or socket wrench to install the four sets of
8.
brackets and bolts that secure the chassis to the wooden pallet.
Slide the plastic cover over the switch chassis. The plastic cover is part of the switch's
9.
original packing materials.
Place the packing foam on top of and around the switch.
10.
Place the power cords in the box.
11.
Remove the adjustable mounting brackets from the rack and place them and their
12.
connecting screws in the accessory box.
If you are returning accessories or FRUs with the switch, pack them as instructed in
13.
"Packing QFX10000 Switch Components for Shipping" on page
Verify that all accessories are present. See
14.
Packing List" on page 146.
Slide the cardboard box over the chassis, making sure that the arrows on the box point
15.
up and the pallet fasteners to secure the cardboard box to the wooden pallet are near
the bottom.
Attach the cardboard box to the wooden pallet by screwing two screws into each of
16.
the four pallet fasteners. See
"Removing a QFX10016 From a 4-Post Rack Using a
263.
"Comparing the QFX10000 Order to the
Figure 169 on page 280
281.
and Figure 170 on page 281.
279