Pinout Specifications; Console Port Connector Pinouts For A Qfx10000; Table 58: Console Port Connector Pinouts For The Qfx Series; Chapter 11 Pinout Specifications - Juniper QFX10016 Hardware Manual

CHAPTER 11

Pinout Specifications

Console Port Connector Pinouts for a QFX10000

Copyright © 2017, Juniper Networks, Inc.
Console Port Connector Pinouts for a QFX10000 on page 135
USB Port Specifications for the QFX Series on page 136
Management Port Connector Pinouts for the QFX Series on page 137
The console port (labeled
that uses an RJ-45 connector to connect to a console management device. The default
baud rate for the console port is 9600 baud.
Table 58 on page 135 provides the pinout information for the RJ-45 console connector.
An RJ-45 cable and RJ-45 to DB-9 adapter are supplied with the QFX10008 and
QFX10016.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a QFX10008 or QFX10016, use
a combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with
the device and a USB to DB-9 male adapter. You must provide the USB to
DB-9 male adapter.

Table 58: Console Port Connector Pinouts for the QFX Series

Pin
1
2
3
) on the Control Board panel is an RS-232 serial interface
CON
Signal
RTS Output
DTR Output
TOD Output for PTP applications
TxD Output
Description
Request to send
Data terminal ready
Time of day for Precision Time
Protocol (PTP). You can use DTR
pins as a TOD universal
asynchronous
receiver/transmitter (UART) by
using breakout cables.
Transmit data
135