Figure 114: Esd Point On Qfx10008 Chassis Rear; Figure 115: Esd Point On Qfx10016 Chassis Rear - Juniper QFX10016 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD) grounding strap
To install a SIB:
Place an electrostatic bag or an antistatic mat on a flat, stable surface.
1.
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
2.
point on the chassis. There is an ESD point located next to the protective earthing
terminal and below
PSU 5
and below PSU_9 on the QFX10016 rear panel (see

Figure 114: ESD Point on QFX10008 Chassis Rear

1— ESD point

Figure 115: ESD Point on QFX10016 Chassis Rear

Remove the appropriate fan tray (see
3.
Either remove the failing SIB (see
4.
on page 221) or remove the cover panel by grasping each side of the plate and pulling
straight out (see Figure 116 on page 218
Chapter 18: Replacing Switch Fabric Cards
on the QFX10008 rear panel (see
Figure 115 on page
"Removing a QFX10000 Fan Tray" on page
"Removing a QFX10000 Switch Interface Board"
for an example using the QFX10008).
Figure 114 on page 217)
217).
180).
217