Installing A Transceiver - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
Related
Documentation

Installing a Transceiver

254
Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat,
6.
stable surface.
Place the dust cover over the empty port.
7.
Installing a Transceiver on page 254
The transceivers for Juniper Networks devices are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the device or disrupting the device functions.
NOTE: After you insert a transceiver or after you change the media-type
configuration, wait for 6 seconds for the interface to display operational
commands.
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
NOTE: On an EX3200 switch, if you install a transceiver in a 1-Gigabit Ethernet
uplink module port, a corresponding network port from the last four built-in
ports is disabled. For example, if you install a transceiver in the uplink module
port 3 (
ge-0/1/2
disabled port is not listed in the output of
Before you begin installing a transceiver in a device, ensure that you have taken the
necessary precautions for safe handling of lasers (see Laser and LED Safety Guidelines
and Warnings).
Ensure that you have a rubber safety cap available to cover the transceiver.
), then the built-in port 23 ( ) is disabled. The
ge-0/0/22
commands.
show interface
Copyright © 2017, Juniper Networks, Inc.