Figure 146: Esd Point On Qfx10008 Chassis Front; Figure 147: Esd Point On Qfx10016 Chassis Front; Figure 148: Removing The Sata Ssd Cover Plate - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
246
To install either size of SATA SSD in a QFX10000:
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the front of the chassis. There is an ESD point located above the status LED
panel on the right side (see

Figure 146: ESD Point on QFX10008 Chassis Front

Figure 147: ESD Point on QFX10016 Chassis Front

1— ESD point
Loosen the two captive screws to remove the cover plate on the Control Board by
2.
using the Phillips (+) screwdriver, number 1 (see

Figure 148: Removing the SATA SSD Cover Plate

Remove the SATA SSD from the electrostatic bag, taking care not to touch the
3.
connectors.
Slide the SATA SSD into the open slot until the pins engage and the faceplate is flush
4.
with the front panel of the Control Board (see
Figure 146 on page 246 and
1
Figure 148 on page
Figure 149 on page
Copyright © 2017, Juniper Networks, Inc.
Figure 147 on page 246).
246).
247).