Mounting A Qfx10016 In A Four-Post Rack Using A Mechanical Lift - Juniper QFX10016 Hardware Manual

Mounting a QFX10016 in a Four-Post Rack Using a Mechanical Lift

Copyright © 2017, Juniper Networks, Inc.
Because of the switch's size and weight, the QFX100016 can only safely be installed
using a mechanical lift.
CAUTION: Do not install line cards in the chassis until after you mount the
chassis securely on a rack or cabinet.
CAUTION: Before front-mounting the switch on a rack or cabinet, have a
qualified technician verify that the rack is strong enough to support the
switch's weight and is adequately supported at the installation site.
Before you install the switch:
Prepare the site for installation as described in
on page 105.
Ensure the site has adequate clearance for both airflow and hardware maintenance
as described in "QFX10000 Clearance Requirements for Airflow and Hardware
Maintenance" on page 111.
Unpack the switch as described in
In a four-post rack, install the mounting brackets at the desired position (see
the Mounting Hardware for a QFX10000" on page
Review chassis lifting guidelines described in Chassis Lifting Guidelines.
Ensure that you have the following parts and tools available to install the switch:
A mechanical lift rated for 1000 lbs. (453.6 kg)
12 mounting screws appropriate for your rack
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your
rack-mounting screws
CAUTION: If you are installing more than one switch in a rack or cabinet,
install the first switch at the bottom of the rack.
Chapter 12: Unpacking and Mounting the Switch
"QFX10000 Site Preparation Checklist"
"Unpacking the QFX10016" on page
150).
142.
"Installing
153