Figure 38: Use The First And Fourth Port In Each 6Xqsfp Cage To Channelize A; Table 21: Qfx10000-36Q Port Mapping - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide

Table 21: QFX10000-36Q Port Mapping

4X10-Gigabit
Port Number Ethernet
0
1
2
3
4
5
6
7
8
9
10
11
58
The port range must be configured using the
command. For example, to channelize the first switch port, use the
0port 1channel-speed 10g
Figure 38: Use the First and Fourth Port in Each 6XQSFP Cage to
Channelize a Port Range
Port 0
Port 3
Use every third port to create a port range for
40-Gigabit Channelization.
Table 21 on page 58 shows the available combinations for the ports. Most 100-Gigabit
Ethernet transceiver ports are used as uplinks.On the QFX10000-36Q, the ports are
enabled by default, and the default configuration adds the ports to the default VLAN.
4X10-Gigabit
Channelized 40-Gigabit
Port Group Ethernet
set chassis fpc pic port channel-speed
command.
100-Gigabit
Ethernet
–
–
–
–
–
–
–
–
set chassis fpc 0 pic
100-Gigabit Ethernet Disables
–
0, 2
–
–
–
3, 4
–
6, 8
–
–
–
9, 10
Copyright © 2017, Juniper Networks, Inc.