Figure 130: Esd Point On Qfx10008 Chassis Front; Figure 131: Esd Point On Qfx10016 Chassis Front - Juniper QFX10016 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
To remove a line card from a QFX10000 switch chassis:
Place the antistatic bag or antistatic mat on a flat, stable surface.
1.
Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD
2.
point above the status LEDs on the switch chassis (see

Figure 130: ESD Point on QFX10008 Chassis Front

1— ESD point

Figure 131: ESD Point on QFX10016 Chassis Front

1— ESD point
Label the cables connected to each port on the line card so you can reconnect the
3.
cables to the correct ports.
Take the line card offline by issuing the following CLI command:
4.
user@switch> request chassis fpc slot slot-number offline
Unscrew the line card from the chassis by continually turning the handles to the left
5.
until the line card is fully unseated. See
Chapter 19: Installing and Replacing Line Cards
Figure 130 on page
1
Figure 132 on page 234.
233).
233