Figure 150: Esd Point On Qfx10008 Chassis Front; Figure 151: Esd Point On Qfx10016 Chassis Front; Figure 152: Removing The Sata Ssd - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
248
To remove either size of SATA SSD in a QFX10000:
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis. There is an ESD point located above the status LED panel on the
right side of the switch chassis (see

Figure 150: ESD Point on QFX10008 Chassis Front

Figure 151: ESD Point on QFX10016 Chassis Front

1— ESD point
Loosen the two captive screws of the SATA SSD on the control panel by using the
2.
Phillips (+) screwdriver, number 1.
Grasp the faceplate of the SATA SSD by the captive screws and slide the drive out of
3.
the control panel (see Figure 152 on page

Figure 152: Removing the SATA SSD

Place the SATA SSD in an electrostatic bag or on an antistatic mat.
4.
Replace the drive with either a new SATA SSD or with a cover plate (see
5.
the Optional SATA Solid State Drive in a QFX10000" on page
Figure 150 on page 248 and
1
248).
Copyright © 2017, Juniper Networks, Inc.
Figure 151 on page 248).
"Installing
245).