MX960 3D Universal Edge Router Hardware Guide
Installing the MX960 Air Filter
326
CAUTION:
Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
CAUTION:
Do not run the router for more than two minutes without the
air filter in place.
Simultaneously pull the two releases labeled
3.
Lift it up and outward to lock it in place to access the air filter.
Pull the filter tray release on both sides of the filter tray.
4.
Slide the air filter tray out of the chassis as shown in
5.
Figure 125: Removing the Normal-Capacity Air Filter Tray from the Chassis
To install the air filter (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Ensure that the air filter is right side up.
2.
Place the air filter into the air filter tray.
3.
PULL
Figure 91 on page
267):
on the standard cable manager.
Figure 125 on page
326.
Copyright © 2017, Juniper Networks, Inc.