Figure 108: Esd Point On Chassis Rear; Figure 109: Esd Point On Qfx10016 Chassis Rear - Juniper QFX10016 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the chassis. There is an ESD point located next
to the protective earthing terminal and below
Figure 108 on page 209) and below

Figure 108: ESD Point on Chassis Rear

1— ESD point

Figure 109: ESD Point on QFX10016 Chassis Rear

1— ESD point
Make sure that the voltage across the DC power source cables leads is 0 V and that
2.
there is no chance that the cables might become active during the removal process.
Ensure the black power supply output switch, to the right of the captive screw, is set
3.
to the standby position.
Unscrew the captive screw counterclockwise by using the Phillips (+) screwdriver,
4.
number 1.
Chapter 17: Replacing Power Supplies
on the QFX10008 rear panel (see
PSU 5
on the QFX10016 (see
PSU_9
Figure 109 on page 209).
209