Related
Documentation
Removing a QFX10000 DC Power Supply
Copyright © 2017, Juniper Networks, Inc.
Set both enable switches to the
not using source redundancy, set the unused source to the
turns red and indicates an error if a source input is not in use and the enable switch is
|
(on).
Figure 107: Setting the Enable Switches for the Power Source
1—
Source input 1
Verify that the input 1 and 2 LEDs on the power supply faceplate are lit and are on
19.
steadily.
Press the power switch to the on (
20.
Removing a QFX10000 DC Power Supply on page 207
Connecting DC Power to a QFX10000 on page 165
Calculating Power Requirements for a QFX10008
Calculating Power Requirements for a QFX10016 Switch on page 114
QFX10000 Field-Replaceable Units on page 20
QFX10000 AC Power Supply on page 43
The DC power supply in a QFX10008 and QFX10016 chassis is a hot-removable and
hot-insertable field-replaceable unit (FRU). You remove DC power supplies from the
rear of the chassis.
Chapter 17: Replacing Power Supplies
(on) position when using both source inputs. When
|
2—
Source input 2
) position.
|
(off) position. The LED
O
207