Table 3-11: Possible Warning Messages At Start-Up - Teledyne T200 Operation Manual

Getting Started

Table 3-11: Possible Warning Messages at Start-Up

MESSAGE
1
SYSTEM RESET
ANALOG CAL WARNING
BOX TEMP WARNING
2
CANNOT DYN SPAN
3
CANNOT DYN ZERO
CONFIG INITIALIZED
DATA INITIALIZED
OZONE FLOW WARNING
4
OZONE GEN OFF
RCELL PRESS WARN
RCELL TEMP WARNING
IZS TEMP WARNING
CONV TEMP WARNING
PMT TEMP WARNING
AZERO WARN [XXXX]
MV
HVPS WARNING
REAR BOARD NOT DET
RELAY BOARD WARN
SAMPLE FLOW WARN
1
Clears 45 minutes after power up.
2
Clears the next time successful zero calibration is performed.
3
Clears the next time successful span calibration is performed.
4
Clears 30 minutes after power up.
5
Only Appears if the IZS option is installed.
66
Teledyne API – T200 NO/NO
The computer has rebooted.
The A/D or at least one D/A channel have not been calibrated.
The temperature inside the T200 chassis is outside the specified limits.
Contact closure span calibration failed while DYN_SPAN was set to ON.
Contact closure zero calibration failed while DYN_ZERO was set to ON.
Configuration storage was reset to factory configuration or erased.
DAS data storage was erased before the last power up occurred.
Ozone gas flow is too high or too low for accurate NO
Ozone generator is off.
This is the only warning message that automatically clears itself.
It clears itself when the ozone generator is turned on.
Upon power up the Ozone generator will remain off for 30 minutes. This allows the ozone
dryer to reach its working dew point.
Reaction cell pressure is too high or too low for accurate NO
Reaction cell temperature is too high or too low for accurate NO
5
IZS temperature is too high or too low for efficient O
NO to NO Converter temperature too high or too low to efficiently convert NO
2
PMT temperature outside of warning limits.
AutoZero reading too high. The value shown in message indicates auto-zero reading at
time warning was displayed.
High voltage power supply output is too high or too low for proper operation of the PMT.
CPU unable to communicate with motherboard..
CPU is unable to communicate with the relay PCA.
The flow rate of the sample gas is outside the specified limits.
/NO Analyzer Operation Manual
2 X
MEANING
, NO and NO
x
, NO and NO
x
, NO and NO
x
production.
3
readings.
2
readings.
2
readings.
2
to NO.
2
06858E DCN7057