Performing A Basic Manual Calibration - Teledyne T200 Operation Manual

Calibration Procedures

9.2.3. PERFORMING A BASIC MANUAL CALIBRATION

9.2.3.1. SETTING THE EXPECTED SPAN GAS CONCENTRATION
Note
Only appears if the AUTO
range mode is selected.
Use these buttons to select
the appropriate range.
Repeat entire procedure for
each range.
The NO & NO span concentration
X
values automatically default to
400.0 PPB.
If this is not the the concentration of
the span gas being used, toggle
these buttons to set the correct
concentration of the NO
calibration gases.
184
Teledyne API – T200 NO/NO
The following section describes the basic method for manually calibrating the T200.
If the analyzer‟s reporting range is set for the AUTO range mode, a step will appear for
selecting which range is to be calibrated (LOW or HIGH). Each of these two ranges
MUST be calibrated separately.
The expected concentrations for both NOx and NO are usually set to the same
value unless the conversion efficiency is not equal to 1.000 or not entered
properly in the conversion efficiency setting.
When setting expected concentration values, consider impurities in your span
gas source (e.g. NO often contains 1-3% NO
The NO and NO span gas concentrations should be 80% of range of concentration
x
values likely to be encountered in your application. The default factory reporting range
setting is 500 ppb and the default span gas concentration is 40.0 ppb.
To set the span gas concentration, press:
SAMPLE
<TST
TST>
SAMPLE
LOW HIGH
M-P CAL
<TST TST> ZERO SPAN
M-P CAL
NOX NO
M-P CAL NOX SPAN CONC:80.0 Conc
0 4
and NO
X
2
RANGE=500.0 PPB NOX= XXXX
CAL
RANGE TO CAL:LOW
ENTR
RANGE=500.0 PPB NOX= XXXX
CONC
CONCENTRATION MENU
CONV
0 0 .0 ENTR EXIT
/NO Analyzer Operation Manual
2 X
and vice versa).
SETUP
EXIT
EXIT
EXIT
EXIT ignores the new
setting and returns to
the previous display.
ENTR accepts the new
setting and returns to
the
CONCENTRATION
MENU.
If using NO span gas
in addition to NO
X
repeat last step.
06858E DCN7057