Teledyne T200 Operation Manual page 97

Teledyne API – T200 NO/NO
Press individual
buttons to set
number.
EXAMPLE: This
password enables the
SETUP mode.
Note
06858E DCN7057
/NO Analyzer Operation Manual
2 X
SAMPLE
<TST
SETUP X.X
SETUP X.X
COMM
SYSTEM
SYSTEM
The instrument still prompts for a password when entering the VARS and DIAG
menus, even if passwords are disabled, but it displays the default password (818)
upon entering these menus. In this case, the user only has to press ENTR to
access the password-protected menus.
In order to disable the PASSWORD feature after it has been turned ON, go to the
SETUP menu, input the password, and press ENTR. In the Primary Setup Menu press
PASS; then press ON to turn PASSWORD ENABLE back to OFF, and press ENTR to
accept and apply the change (no need to press EXIT from the Primary Setup Menu this
time).
RANGE=500.0 PPB
TST> CAL
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SECONDARY SETUP MENU
VARS DIAG
ENTER SETUP PASS:0
0 0 0
ENTER SETUP PASS:0
8 1 8
Instrument enters selected menu.
Setup Mode Menus
NOX= XXXX
SETUP
EXIT
MORE
EXIT
ENTR EXIT
EXIT
ENTR
95