Teledyne T200 Operation Manual page 87

Teledyne API – T200 NO/NO
Toggle these
buttons to select
the upper SPAN
limit for the shared
NO , NO and NO
X
reporting range.
Toggle these buttons to select the
upper SPAN limit for the O
reporting range.
NOTE: O RANGE only appears if
2
the optional O sensor is installed.
2
06858E DCN7057
/NO Analyzer Operation Manual
2 X
Although all three NO
electronic signal ranges of the analog outputs may still be configured for different values
(e.g. 0-5 VDC, 0-10 VDC, etc; see Section 5.9.3.1).
To select SNGL range mode and to set the upper limit of the range, press:
SAMPLE
<TST TST> CAL
SETUP X.X
CFG DAS
SETUP X.X
MODE SET UNIT DIL
SETUP X.X
SNGL IND AUTO
SETUP X.X
SNGL IND AUTO
SETUP X.X
MODE SET
SETUP X.X
0 0
2
SETUP X.X
1 0
2
outputs share the same concentration reporting range, the
x
RANGE=500.0 PPB NOX= XXXX
PRIMARY SETUP MENU
RNGE PASS CLK MORE
RANGE MODE MENU
RANGE MODE:SNGL
ENTR EXIT
RANGE MODE:SNGL
ENTR
RANGE MODE MENU
UNIT DIL
RANGE:500.0 Conc
5 0 0 .0 ENTR EXIT
O2 RANGE:100.00 %
0 .0 0 ENTR EXIT
Setup Mode Menus
SETUP
Concentration field
displays all gases.
EXIT
EXIT
EXIT
EXIT
EXIT discards the new
setting.
ENTR accepts the
new setting.
85