Teledyne T200 Operation Manual page 118

Setup Mode Menus
5.9.3.8. TURNING AN ANALOG OUTPUT OVER-RANGE FEATURE ON/OFF
Toggle this
button to turn
the Over-
Range feature
ON/OFF.
116
Teledyne API – T200 NO/NO
In its default configuration, a ± 5% over-range is available on each of the T200‟s analog
outputs. This over-range can be disabled if your recording device is sensitive to excess
voltage or current.
To turn the over-range feature on or off, select the ANALOG I/O CONFIGURATION
submenu (see Figure 5-5) then press:
AIO CONFIGURATION SUBMENU
DIAG
PREV NEXT
DIAG AIO
SET>
Continue pressing SET> until you reach the
DIAG AIO
<SET SET>
DIAG AIO
SET>
DIAG AIO
<SET SET>
DIAG AIO
ON
DIAG AIO
OFF
From the
ANALOG I/O CONFIGURATION
ENTR
AOUTS CALIBRATED: NO
CAL
output to be configured
CONC_OUT_2: 5V, OVR, NOCAL
EDIT
CONC_OUT_2: RANGE: 5V
EDIT
CONC_OUT_2: OVERRANGE: ON
EDIT
CONC_OUT_2: OVERRANGE: ON
CONC_OUT_2: OVERRANGE: OFF
/NO Analyzer Operation Manual
2 X
EXIT
EXIT
EXIT
EXIT
EXIT
ENTR EXIT
EXIT
ENTR
06858E DCN7057