Teledyne T200 Operation Manual page 167

Teledyne API – T200 NO/NO
7.1.3.9. THE COMPACT REPORT FEATURE
7.1.3.10. THE STARTING DATE FEATURE
7.1.3.11. DISABLING/ENABLING DATA CHANNELS
Use the PREV and
NEXT buttons to
scroll to the DATA
CHANNEL to be
edited.
Toggle these buttons
to enable or disable
the CHANNEL.
06858E DCN7057
/NO Analyzer Operation Manual Data Acquisition System (DAS) and APICOM
2 X
When enabled, this option avoids unnecessary line breaks on all RS-232 reports. Instead
of reporting each parameter in one channel on a separate line, up to five parameters are
reported in one line.
The COMPACT DATA REPORT generally cannot be accessed from the standard
DAS front panel menu, but is available via the instrument‟s communication ports by
using APICOM or the analyzer‟s standard serial data protocol.
This option allows the user to specify a starting date for any given channel when the user
wants to start data acquisition only after a certain time and date. If the STARTING
DATE is in the past (the default condition), the DAS ignores this setting and begins
recording data as defined by the REPORT PERIOD setting.
The STARTING DATE generally cannot be accessed from the standard DAS front
panel menu, but is available via the instrument‟s communication ports by using
APICOM or the analyzer‟s standard serial data protocol.
Data channels can be temporarily disabled, which can reduce the read/write wear on the
Disk-on-Module (DOM).
To disable a data channel, go to the DAS>EDIT menu as shown in Section 7.1.3 then
continue as follows:
Starting at the EDIT CHANNEL MENU
SETUP X.X
PREV NEXT
SETUP X.X
<SET SET>
Continue pressing <SET or SET> until ...
SETUP X.X
<SET SET>
SETUP X.X
ON
0) CONC: ATIMER 5, 800
INS DEL PRNT
EDIT
NAME: CONC
EDIT PRNT
CHANNEL ENABLE:ON
EDIT
CHANNEL ENABLE:ON
ENTR EXIT
EXIT
EXIT
EXIT
EXIT discards the new
setting.
ENTR accepts the
new setting.
165