Com Port Baud Rate; Com Port Testing; Figure 6-2. Com - Com Port Baud Rate - Teledyne T200 Operation Manual

Communications Setup and Operation

6.2.2. COM PORT BAUD RATE

Select which COM
port to configure.
(COM1 for example).
Press SET> until you
reach the COM1
BAUD RATE
Use PREV and NEXT
to move between
available baud rates.
300
1200
4800
9600
19200
38400
57600
115200

6.2.3. COM PORT TESTING

126
Teledyne API – T200 NO/NO
To select the baud rate of either COM Port, go to SETUP>MORE>COM and select
either COM1 or COM2 as follows (use COM2 to view/match your personal computer
baud rate when using the USB port, Section 6.6):
SETUP X.X
ID INET
COM1
EXIT
SETUP X.X
EDIT
SET>
EXAMPLE
SETUP X.X
<SET SET>
EDIT
SETUP X.X
PREV NEXT
SETUP X.X
ON
NEXT
Figure 6-2.
The serial ports can be tested for correct connection and output in the COM menu. This
test sends a string of 256 „w‟ characters to the selected COM port. While the test is
running, the red LED on the rear panel of the analyzer should flicker.
COMMUNICATIONS MENU
COM2
COM1 MODE:0
COM1 BAUD RATE:19200
COM1 BAUD RATE:19200
ENTR
COM1 BAUD RATE:9600
ENTR
COM – COM Port Baud Rate
/NO Analyzer Operation Manual
2 X
EXIT
EXIT
ignores
EXIT
the new
setting
EXIT
EXIT
06858E DCN7057
ENTR
accepts
the new
setting