Ac Power Configuration - Teledyne T200 Operation Manual

Principles of Operation
SENSOR MODULE
ANALOG
SENSORS
(e.g. Temp
Sensors, Flow
Sensors)
O
3
Generator
PUMP
(Internal Only)
AC HEATERS
NO2  NO
(Converter &
Reaction Cell)
Optional
AC HEATERS
( Internal Span
Generator Perm Tube
Heater)
MODEL SPECIFIC
(e.g. NO
Auto-zero valves, etc.)

13.7.1. AC POWER CONFIGURATION

322
Teledyne API – T200 NO/NO2/NOx Analyzer Operation Manual
Pre-Amplifiers
& Amplifiers HVPS
Sensor Control
& I/O Logic
LOGIC DEVICES
(e.g. CPU, I
MotherBoard, etc.)
Configuration
Jumpers
Configuration
Jumpers
Solenoid
Drivers
RELAY PCA
OPTIONAL
VALVES
VALVES
– NO Valves,
(e.g. Sample/Cal,
X
Zero/Span, Shutoff,
etc.)
Figure 13-22: Power Distribution Block Diagram
The T200 analyzer‟s digital components will operate with any of the specified power
regimes. As long as instrument is connected to 100-120 VAC or 220-240 VAC at either
50 or 60 Hz,. Internally, the status LEDs located on the Relay PCA, Motherboard and
CPU should turn on as soon as the power is supplied.
However, some of the analyzer‟s non-digital components, such as the various internal
pump options or the AC powered heaters for the NO
and some of the T200‟s must be properly configured for the type of power being
supplied to the instrument.
Configuration of the power circuits is set using several jumper sets located on the
instruments relay PCA.
PMT
2
C bus,
PS 1
+5 VDC
±15 VDC
PS 2
(+12 VDC)
Fans:
TEC and
Chassis
2
KEY
AC POWER
DC POWER
ON / OFF
SWITCH
AC
POWER IN
 NO converter the reaction cell
06858E DCN7057