Teledyne T200 Operation Manual page 141

Teledyne API – T200 NO/NO
6.7.2.2. ACTIVATING HESSEN PROTOCOL
Use the PREV and
NEXT buttons to
between the
available modes.
Activate / Deactivate
the HESSEN mode
by toggling the ON /
OFF button.
06858E DCN7057
/NO Analyzer Operation Manual
2 X
Once the COM port has been properly configured, the next step in configuring the T200
in order to operate over a Hessen protocol network is to activate the Hessen mode for
COM ports and configure the communication parameters for the port(s) appropriately.
To activate the Hessen Protocol, press:
SAMPLE RANGE=500.0 PPB
<TST TST> CAL
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X
SECONDARY SETUP MENU
VARS DIAG
COMM
SETUP X.X
COMMUNICATIONS MENU
ID COM2
COM1
SETUP X.X
COM1 MODE:0
<SET SET>
EDIT
SETUP X.X
COM1 QUIET MODE:OFF
PREV OFF
NEXT
Continue pressing NEXT until ...
SETUP X.X
COM1 HESSEN PROTOCOL: OFF
PREV NEXT OFF
SETUP X.X
COM1 HESSEN PROTOCOL: OFF
PREV NEXT ON
SETUP X.X
COM1 MODE:16
<SET SET>
EDIT
SETUP X.X
COMMUNICATIONS MENU
ID COM1 COM2
HESN
Communications Setup and Operation
NOX= XXXX
SETUP
Concentration field
displays all gases.
EXIT
MORE
EXIT
EXIT
Combined Mode ID
displayed here.
EXIT
EXIT
ENTR EXIT
EXIT discards the new
ENTR EXIT
ENTR accepts the
EXIT
EXIT
setting.
new setting.
139