Teledyne T200 Operation Manual page 72

Getting Started
Verify that the MODE
is set for SNGL.
If it is not, press
SINGL ENTR
Verify that the RANGE is
set for 500.0
If it is not, toggle each
numeric key until the
proper range is set, then
press ENTR.
Verify that the UNIT is
set for PPB
If it is not, press
PPB ENTR
I
MPORTANT
70
Teledyne API – T200 NO/NO
SAMPLE
<TST TST> CAL
SETUP X.X
CFG DAS
SETUP X.X
SET UNIT
MODE
SETUP X.X
SNGL IND AUTO
SETUP X.X
MODE
SET
SETUP X.X
0 0
SETUP X.X
SET UNIT
MODE
SETUP X.X
PPB PPM UGM MGM
V E
ERIFYING THE XPECTED
Verify the PRECISE Concentration Value of the SPAN gases independently.
If you supply NO gas to the analyzer, the values for expected NO and NO
MUST be identical.
The NO and NO span concentration values automatically defaults to 400.0 PPB and it
x
is recommended that calibration gases of that concentration be used for the initial
calibration of the unit.
RANGE=500.0 PPB NOX= XXXX
PRIMARY SETUP MENU
PASS CLK MORE
RNGE
RANGE CONTROL MENU
DIL
RANGE MODE:SINGL
RANGE CONTROL MENU
UNIT DIL
RANGE: 500.0 Conc
5 0 0 .0
RANGE CONTROL MENU
DIL
CONC UNITS:PPB
NO NO S
AND PAN
X
I R
MPACT ON EADINGS OR
/NO Analyzer Operation Manual
2 X
SETUP
EXIT
EXIT
ENTR
EXIT
EXIT
ENTR
EXIT
Press EXIT
3x's to return to
SAMPLE mode.
EXIT
ENTR
EXIT
G C
AS ONCENTRATION
D
ATA
06858E DCN7057
x