Teledyne T200 Operation Manual page 137

Teledyne API – T200 NO/NO

Note

06858E DCN7057
/NO Analyzer Operation Manual
2 X
Baud Rate: 115200
COM2 Mode Settings:
Quiet Mode
Computer Mode
MODBUS RTU
MODBUS ASCII
E,8,1 MODE
E,7,1 MODE
RS-485 MODE
SECURITY MODE
MULTIDROP MODE
ENABLE MODEM
ERROR CHECKING
XON/XOFF HANDSHAKE OFF
HARDWARE HANDSHAKE OFF
HARDWARE FIFO
COMMAND PROMPT
6. Next, configure your communications software, such as APIcom. Use the COM port
determined in Step 4 and the baud rate set in Step 5. The figures below show how
these parameters would be configured in the Instrument Properties window in
APIcom when configuring a new instrument. See the APIcom manual (PN 07463)
for more details.
USB configuration requires that the baud rates of the instrument and the PC
match; check the PC baud rate and change if needed.
Using the USB port disallows use of the rear panel COM2 port except for
multidrop communication.
Communications Setup and Operation
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
OFF
135