Figure 4-2: Viewing T200 Test Functions; Table 4-2: Test Functions Defined - Teledyne T200 Operation Manual

Teledyne API – T200 NO/NO

Table 4-2: Test Functions Defined

DISPLAY PARAMETER
RANGE
RANGE1
RANGE2 RANGE
RANGE1
RANGE2
RANGE3
STABILITY
NOX STB
SAMPFLOW
SAMP FLW
OZONEFLOW
OZONE FL
PMT
NORMPMT
NORM PMT
AUTOZERO
AZERO
06858E DCN7057
/NO Analyzer Operation Manual
2 X
SAMPLE RANGE=500.0 PPB
<TST TST> CAL
Toggle <TST TST> buttons
to scroll through list of
functions
1 This will match the currently selected units of measure
for the range being displayed.
2 The STB function can be set to display data related to
any of the gasses the analyzer measures, e.g. NOX,
NO, NO2 or O (if the O
2
3 Only appears if IZS option is installed.
4 Only appears if analog output A4 is actively reporting
a TEST FUNCTION.
Figure 4-2:
UNITS
PPB,
PPM,
UGM
&
MGM
PPB
CC/M
CC/M
PMT MV
MV
MV
NOX= XXXX
SETUP
sensor option is installed.
2
Viewing T200 Test Functions
DESCRIPTION
The Full Scale limit at which the reporting range of the analyzer's ANALOG
OUTPUTS is currently set.
THIS IS NOT the Physical Range of the instrument. See Section
more information.
If AUTO Range mode has been selected, two RANGE functions will
appear, one for each range:
 RANGE1: The range setting for all analog outputs.
 RANGE2: The HIGH range setting for all analog outputs.
If the IND Range mode has been selected, three RANGE functions will
appear, one for each range:
 RANGE1: NO
concentration output un A1.
x
 RANGE2: NO concentration output un A2.
 RANGE2: NO
concentration output un A3.
2
The standard deviation of concentration readings of the selected gas.
 Data points are recorded every ten seconds. The calculation uses the
last 25 data points.
Gas flow rate of the sample gas into the reaction cell.
Gas flow rate of O gas into the reaction cell.
3
The raw signal output of the PMT.
The signal output of the PMT after is has been normalized for temperature,
pressure, auto-zero offset, but not range.
The PMT signal with zero NO
X
This offset is subtracted from the PMT signal and adjusts for variations in
the zero signal.
Overview of Operating Modes

2
NO=[Value]PPB

2
NOX=[Value]PPB

RANGE=[Value]PPB

RANGE1=[Value]PPB

RANGE2=[Value]PPB

NOX STB=[Value]PPB

SAMP FLW=[Value]CC/M

OZONE FL=[Value]CC/M

PMT=[Value]MV

NORM PMT=[Value]MV

AZERO=[Value]MV

HVPS=[Value]V

RCELL TEMP=[Value]ºC

BOX TEMP=[Value]ºC

PMT TEMP=[Value]ºC

IZS TEMP=[Value]ºC

MOLY TEMP=[Value]ºC

RCEL=[Value]IN-HG-A

SAMP=[Value]IN-HG-A

NOX SLOPE=[Value]

NOX OFFS=[Value]MV

NO SLOPE=[Value]

NO OFFS=[Value]MV

4
TEST=[Value]MV

TIME=[HH:MM:SS]
, which is usually slightly different from 0 V.
1
1
1
2
3
5.4.1
for
75