Table 3-3: Possible Warning Messages At Start-Up - Teledyne 400E Instruction Manual

Model 400E Ozone Analyzer
Instruction Manual
Message
LAMP DRIVER WARN
BOX TEMP WARNING
CONFIG INITIALIZED
DATA INITIALIZED
FRONT PANEL WARN
PHOTO REF WARNING
PHOTO TEMP WARNING
REAR BOARD NOT DET
RELAY BOARD WARN
SAMPLE FLOW WARN
SAMPLE PRESS WARN
SAMPLE TEMP WARN
SYSTEM RESET
O3 GEN LAMP WARN
O3 GEN REF WARNING
O3 GEN TEMP WARN
O3 SCRUB TEMP WARN
P/N 04316 Rev: B
Table 3-3: Possible Warning Messages at Start- Up
CPU is unable to communicate with one of the I2C UV Lamp
Drivers.
The temperature inside the M400E chassis is outside the
specified limits.
Configuration storage was reset to factory configuration or
erased.
iDAS data storage was erased.
CPU is unable to communicate with the front panel.
The O
3
The UV Lamp Temperature is outside of specified limits.
Motherboard was not detected during power up.
CPU is unable to communicate with the relay board.
The flow rate of the sample gas is outside the specified limits.
The pressure of the sample gas is outside the specified limits.
The temperature of the sample gas is outside the specified
limits.
The computer has rebooted.
The UV Lamp or Detector in the IZS module may be faulty or
out of adjustment.
The UV Lamp or Detector in the IZS module may be faulty or
out of adjustment.
The UV Lamp Heater or Temperature Sensor in the IZS
module may be faulty.
The Heater or Temperature Sensor of the O
be faulty (Optional Metal Wool Scrubber only.)
Meaning
Reference value is outside of specified limits.
Getting Started
Scrubber may
3
35