Teledyne T200 Operation Manual page 355

Teledyne API - T200, T204 and 200E Series (05295F DCN6900)
1
Warning Name
WRCELLPRESS
WBOXTEMP
WRCELLTEMP
4
WMANIFOLDTEMP
8
WCO2CELLTEMP
5
WO2CELLTEMP
13
WO3CELLTEMP
13
WO3PHOTOREF
13
WO3LAMPTEMP
13
WO3PRESSURE
WIZSTEMP
WCONVTEMP
WPMTTEMP
WAUTOZERO
11
WPREREACT
WHVPS
WDYNZERO
WDYNSPAN
WREARBOARD
WRELAYBOARD
06858E DCN7057
Message Text
RCELL PRESS WARN
BOX TEMP WARNING
RCELL TEMP WARNING
MANIFOLD TEMP WARN
CO2 CELL TEMP WARN
O2 CELL TEMP WARN
O3 CELL TEMP WARN
O3 CELL PHOTOREF WARN
O3 CELL LAMP WARN
O3 CELL PRESS WARN
IZS TEMP WARNING
CONV TEMP WARNING
PMT TEMP WARNING
AZERO WRN XXX.X MV
PRACT WRN XXX.X MV
HVPS WARNING
CANNOT DYN ZERO
CANNOT DYN SPAN
REAR BOARD NOT DET
RELAY BOARD WARN
Appendix A3: Warnings and Test Measurements, Software Version K.3
Reaction cell pressure outside of
warning limits.
Chassis temperature outside of
warning limits.
Reaction cell temperature outside of
warning limits.
Bypass or dilution manifold
temperature outside of warning
limits.
CO sensor cell temperature outside
2
of warning limits.
O sensor cell temperature outside of
2
warning limits.
O sensor sample temperature
3
outside of warning limits.
O sensor photometer reference
3
signal warning.
O cell lamp temperature warning.
3
O cell pressure warning.
3
IZS temperature outside of warning
limits.
Converter temperature outside of
warning limits.
PMT temperature outside of warning
limits.
Auto-zero reading above limit. Value
shown in message indicates auto-
11
zero reading at time warning was
displayed.
High voltage power supply output
outside of warning limits.
Contact closure zero calibration
failed while DYN_ZERO was set to
ON.
Contact closure span calibration
failed while DYN_SPAN was set to
ON.
Rear board was not detected during
power up.
Firmware is unable to communicate
with the relay board.
Description
A-11