Signal I/O - Teledyne T200 Operation Manual

Setup Mode Menus

5.9.1. SIGNAL I/O

I
MPORTANT
104
Teledyne API – T200 NO/NO
Use the signal I/O diagnostic mode to review and change the digital and analog
input/output functions of the analyzer. Refer to Appendix A for a list of the parameters
available for review under this menu.
Any changes of signal I/O settings will remain in effect only until the signal I/O
menu is exited. Exceptions are the Ozone Generator Override and the Flow
Sensor calibration, which remain as entered when exiting.
Access the signal I/O test mode from the DIAG Menu (Figure 5-4), then press:
DIAG
SIGNAL I / O
JUMP
PREV NEXT
DIAG I / O
0) EXT_ZERO_CAL=OFF
PREV NEXT
JUMP
EXAMPLE
DIAG I / O
JUMP TO: 12
1 2
DIAG I / O
12) ST_SYSTEM_OK = ON
PREV NEXT JUMP
Toggle ON/(OFF) button to
change status.
2
I R
MPACT ON EADINGS OR
EXIT
ENTR
PRNT EXIT
EXIT
ENTR
PRNT
ON EXIT
Pressing the PRNT button will send a formatted
printout to the serial port and can be captured
with a computer or other output device.
/NO Analyzer Operation Manual
X
D
ATA
Press NEXT & PREV to
move between signal
types.
Press JUMP to go
directly to a specific
signal
See Appendix A-4 for
a complete list of
available SIGNALS
EXAMPLE:
Enter 12 to Jump to
12) ST_SYSTEM_OK=ON
Exit to return
to the
DIAG menu
06858E DCN7057