Connections And Setup; Electrical Connections - Teledyne T200 Operation Manual

Teledyne API – T200 NO/NO

3.3. CONNECTIONS AND SETUP

3.3.1. ELECTRICAL CONNECTIONS

Note
3.3.1.1. CONNECTING POWER
High Voltages are present inside the analyzers case.
Power connection must have functioning ground connection.
Do not defeat the ground wire on power plug.
Turn off analyzer power before disconnecting or connecting electrical
subassemblies.
Do not operate with cover off.
To avoid damage to your analyzer, ensure that the AC power voltage
matches the voltage indicated on the analyzer's model/specs label (Figure
3-4) before plugging the T200 into line power.
06858E DCN7057
/NO Analyzer Operation Manual
2 X
This section presents the electrical (Section 3.3.1) and pneumatic (Section 3.3.2)
connections for setup and preparing the instrument for operation.
To maintain compliance with EMC standards, cable length must be no greater
than 3 meters for all I/O connections, which include Analog In, Analog Out, Status
Out, Control In, Ethernet/LAN, USB, RS-232, and RS-485.
Attach the power cord to the analyzer and plug it into a power outlet capable of carrying
at least 10 A current at your AC voltage and that it is equipped with a functioning earth
ground.
WARNING
E S H
LECTRICAL HOCK AZARD
CAUTION
G S H
ENERAL AFETY AZARD
Getting Started
33