Table 3-13: Possible Warning Messages At Start-Up - Teledyne T300 Operation Manual

Teledyne API – Model T300/T300M CO Analyzer

Table 3-13: Possible Warning Messages at Start-Up

Message
ANALOG CAL WARNING
BENCH TEMP WARNING
BOX TEMP WARNING
CANNOT DYN SPAN
CANNOT DYN ZERO
CONFIG INITIALIZED
DATA INITIALIZED
PHOTO TEMP WARNING
REAR BOARD NOT DET
RELAY BOARD WARN
SAMPLE FLOW WARN
SAMPLE PRESS WARN
SAMPLE TEMP WARN
SOURCE WARNING
SYSTEM RESET
WHEEL TEMP WARNING
1
Typically clears 45 minutes after power up.
2
Clears the next time successful zero calibration is performed.
3
Clears the next time successful span calibration is performed.
06864B DCN6314
Table 3-13 lists brief descriptions of the warning messages that may occur during start
up.
The instrument's A/D circuitry or one of its analog outputs is not calibrated.
Optical bench temperature is outside the specified limits.
The temperature inside the T300/T300M chassis is outside the specified limits.
Remote span calibration failed while the dynamic span feature was set to
2
turned on.
Remote zero calibration failed while the dynamic zero feature was set to turned
3
on.
Configuration was reset to factory defaults or was erased.
DAS data storage was erased.
Photometer temperature outside of warning limits specified by
PHOTO_TEMP_SET variable.
Motherboard was not detected during power up.
CPU is unable to communicate with the relay PCA.
The flow rate of the sample gas is outside the specified limits.
Sample pressure outside of operational parameters.
The temperature of the sample gas is outside the specified limits.
The IR source may be faulty.
1
The computer was rebooted.
The Gas Filter Correlation Wheel temperature is outside the specified limits.
Table 3-14 lists brief descriptions of the warning messages that may occur during start
up for T300 analyzers with optional second gas options or alarms installed.
MEANING
Getting Started
77