Getting Started; Unpacking The T200 Analyzer - Teledyne T200 Operation Manual

3.

GETTING STARTED

3.1. UNPACKING THE T200 ANALYZER

ATTENTION
Note
06858E DCN7057
This section addresses the procedures for unpacking the instrument and inspecting for
damage, presents clearance specifications for proper ventilation, introduces the
instrument layout, then presents the procedures for getting started: making electrical and
pneumatic connections, and conducting an initial function and calibration check.
To avoid personal injury, always use two persons to lift and carry the T200.
COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Printed Circuit Assemblies (PCAs) are sensitive to electro-static discharges too
small to be felt by the human nervous system. Failure to use Electro-Static
Discharge (ESD) protection when working with electronic assemblies will void
the instrument warranty. Refer to the manual, Fundamentals of ESD, PN 04786,
which can be downloaded from our website at
under Help Center > Product Manuals in the Special Manuals section.
Do not operate this instrument until you've removed dust plugs from SAMPLE
and EXHAUST ports on the rear panel.
Teledyne API recommends that you store shipping containers/materials for
future use if/when the instrument should be returned to the factory for repair
and/or calibration service. See Warranty section in this manual and shipping
procedures on our Website at
Support > Return Authorization.
CAUTION
G S H
ENERAL AFETY AZARD
http://www.teledyne-api.com
CAUTION!
http://www.teledyne-api.com under Customer
23