Table of Contents
Advertisement
Teledyne API – T200 NO/NO
5.9.3.4. AUTOMATIC GROUP CALIBRATION OF THE ANALOG OUTPUTS
I
MPORTANT
I
MPORTANT
TEST_OUTPUT replaced
by CONC_OUT_4
(O
Concentration)
2
on analyzers with the
optional O
sensor
2
installed.
Analyzer
automatically
calibrates all
channels for which
AUTO-CAL is turned
ON
If any of the channels have not
been calibrated or if at least one
channel has AUTO-CAL turned
OFF, this message will read NO.
06858E DCN7057
/NO
Analyzer Operation Manual
2
X
Manual calibration should be used for any analog output set for a 0.1V output
range or in cases where the outputs must be closely matched to the
characteristics of the recording device. (See Sections 5.9.3.2, 5.9.3.3, and 5.9.3.6).
Before performing this procedure, ensure that the AUTO CAL for each analog
output is enabled. (See Section 5.9.3.3).
To calibrate the outputs as a group with the AOUTS CALIBRATION command, select
the ANALOG I/O CONFIGURATION submenu (see Figure 5-5) then press:
AIO CONFIGURATION SUBMENU
DIAG
ANALOG I/O CONFIGURATION
PREV NEXT
DIAG AIO
SET>
CAL
DIAG AIO
AUTO CALIBRATING CONC_OUT_1
DIAG AIO
DIAG AIO
DIAG AIO
DIAG AIO
SET> CAL
I
R
MPACT ON
EADINGS OR
I
R
MPACT ON
EADINGS OR
From the
ENTR
AOUTS CALIBRATED: NO
NOT AUTO CAL. CONC_OUT_2
AUTO CALIBRATING CONC_OUT_3
AUTO CALIBRATING TEST_OUTPUT
AOUTS CALIBRATED: NO
Setup Mode Menus
D
ATA
D
ATA
EXIT
EXIT
This message
appears when
AUTO-CAL is
turned OFF for a
channel
EXIT
109
Advertisement
Table of Contents
Troubleshooting
