Figure 6-5. Com - Lan / Internet Automatic Configuration (Dhcp) - Teledyne T200 Operation Manual

Communications Setup and Operation
COMMUNICATIONS MENU
SETUP X.X
ID COM1
INET
SAMPLE
ENTER SETUP PASS : 818
8 1 8
SETUP X.X
DHCP: ON
SET> EDIT
INST IP: 0.0.0.0
SETUP X.X
<SET SET>
GATEWAY IP: 0.0.0.0
SETUP X.X
<SET SET>
SUBNET MASK: 0.0.0.0
SETUP X.X
<SET SET>
TCP PORT: 3000
SETUP X.X
EDIT
<SET SET>
TCP PORT2: 502
SETUP X.X
EDIT
<SET SET>
HOSTNAME:
SETUP X.X
EDIT
<SET
Figure 6-5.
Note
132
Teledyne API – T200 NO/NO
COM2
ENTR
EXIT
EXIT
EXIT
EXIT
COM – LAN / Internet Automatic Configuration (DHCP)
If the gateway IP, instrument IP and the subnet mask are all zeroes (i.e.,
―0.0.0.0‖), the DCHP was not successful in which case you may have to configure
the analyzer's Ethernet properties manually. See your network administrator.
From this point on,
EXIT
EXIT returns to
COMMUNICATIONS
MENU
EXIT
DHCP: ON is
default setting.
If it has been
set to OFF,
press EDIT
and set to ON.
EXIT
EDIT button
disabled
EXIT
EXIT
Do not alter unless
directed to by Teledyne
Instruments Customer
Service personnel
/NO Analyzer Operation Manual
2 X
SETUP X.X
DHCP: OFF
OFF ENTR EXIT
EXIT
SETUP X.X
DHCP: ON
ON ENTR
06858E DCN7057
EXIT