Warning Messages - Teledyne T200 Operation Manual

Teledyne API – T200 NO/NO

4.1.2. WARNING MESSAGES

Table 4-3: Warning Messages Defined
MESSAGE
ANALOG CAL WARNING
AZERO WARN
BOX TEMP WARNING
CANNOT DYN SPAN
CANNOT DYN ZERO
CONFIG INITIALIZED
CONV TEMP WARNING
DATA INITIALIZED
HVPS WARNING
IZS TEMP WARNING
OZONE FLOW WARNING
OZONE GEN OFF
PMT TEMP WARNING
RCELL PRESS WARN
RCELL TEMP WARNING
REAR BOARD NOT DET
RELAY BOARD WARN
SAMPLE FLOW WARN
SYSTEM RESET
1
Only Appears if the Internal Span Gas Generator option is installed.
06858E DCN7057
/NO Analyzer Operation Manual
2 X
Warning Messages, listed in Table 4-3, are displayed on the analyzer‟s front panel when
failures occur.
The A/D or at least one D/A channel has not been calibrated.
Auto-zero reading above set limit. Value shown in message indicates auto-zero
reading at time warning was displayed.
The temperature inside the T200 chassis is outside the specified limits.
Contact closure span calibration failed while DYN_SPAN was set to ON.
Contact closure zero calibration failed while DYN_ZERO was set to ON.
Configuration storage was reset to factory configuration or erased.
NO  NO converter temperature outside of warning limits.
2
DAS data storage was erased before the last power up occurred.
High voltage power supply output outside of warning limits.
1 IZS temperature outside of warning limits specified by IZS_SET variable.
Ozone flow outside of warning limits.
Ozone generator is off. This warning message clears itself when the ozone
generator is turned on.
PMT temperature outside of warning limits.
Reaction cell pressure outside of warning limits.
Reaction cell temperature outside of warning limits.
Motherboard was not detected during power up.
CPU is unable to communicate with the relay PCA.
The flow rate of the sample gas is outside the specified limits.
The computer has rebooted.
Overview of Operating Modes
MEANING
77