Table of Contents
Advertisement
Operating Instructions
MODE OR FEATURE
External Communication
Channel Configuration
System Status Variables
System Diagnostic Features
and
Analog Output Configuration
Alarm Limit Configuration
1
Only present if the optional alarm relay outputs (Option 61) are installed.
Note
4.5. SETUP CFG: VIEWING THE ANALYZER'S
CONFIGURATION INFORMATION
76
Table 4-5: Secondary Setup Mode Features and Functions
KEYPAD
LABEL
Used to set up and operate the analyzer's various external I/O
COMM
channels including RS-232; RS 485, modem communication
and/or Ethernet access.
Used to view various variables related to the instruments current
VARS
operational status
Used to access a variety of functions that are used to configure,
test or diagnose problems with a variety of the analyzer's basic
systems.
DIAG
Most notably, the menus used to configure the output signals
generated by the instruments Analog outputs are located here.
Used to turn the instrument's two alarms on and off as well as
1
ALRM
set the trigger limits for each.
Any changes made to a variable during one of the following procedures is not
acknowledged by the instrument until the ENTR button is pressed. If the EXIT
button is pressed before the ENTR button, the analyzer will beep, alerting the
user that the newly entered value has not been accepted.
Pressing the CFG key displays the instrument configuration information. This display
lists the analyzer model, serial number, firmware revision, software library revision,
CPU type and other information. Use this information to identify the software and
hardware when contacting Technical Support. Special instrument or software features
or installed options may also be listed here.
Teledyne API - Model T200H/T200M Operation Manual
DESCRIPTION
MANUAL
SECTION
6.11 &
6.15
6.12
6.13
6.14
07270D DCN7141
Advertisement
Table of Contents
