Setup Menu: Features/Functions Configuration; Setup>Data Logging (Data Acquisition System, Das); Figure 2-20. Datalog Configuration, New Log Page; Figure 2-21. Datalog Configuration, Existing Log - Teledyne N500 User Manual

SETUP MENU: FEATURES/FUNCTIONS CONFIGURATION

Use the Setup menu to configure the instrument's software features, to gather information
on the instrument's performance, and to configure and access data from the Datalogger,
the instrument's internal data acquisition system (DAS). Once the setups are complete,
the saved configurations can be downloaded to a USB drive through the Utilities>USB
Utilities menu and uploaded to other instruments of the same model (Section 2.6).
SETUP>DATA LOGGING (DATA ACQUISITION SYSTEM, DAS)
The Datalogger can be configured to capture and store user-defined data, which then can
be viewed in the Alerts page, if elected, as well as downloaded from the instrument to a
USB flash drive or using NumaView™ Remote software for examination and analysis.
Figure 2-20 shows a new log; Figure 2-21 shows a sample existing log, which can be
edited or deleted, and Figure 2-22 provides illustrated instructions for setting up a new
log, with Sections 2.5.1.1 and 2.5.1.2 providing additional details.
To transfer captured instrument data to a flash drive, see Section 2.5.1.3.

Figure 2-20. Datalog Configuration, New Log Page

Figure 2-21. Datalog Configuration, Existing Log

38 Teledyne API N500 CAPS NO Analyzer with NumaView™ Software
089770000 Rev 05
X