Calibration Mode; Setup Mode; Password Security - Teledyne t100 Operation Manual

Teledyne API - T100 UV Fluorescence SO
4.2.

CALIBRATION MODE

I
MPORTANT
4.3.

SETUP MODE

4.3.1.

PASSWORD SECURITY

06807F DCN7335
Analyzer
2
Pressing the CAL button switches the analyzer into calibration mode. In this mode, the
user can calibrate the instrument with the use of calibrated zero or span gases.
If the instrument includes either the zero/span valve option or IZS option, the display
will also include CALZ and CALS buttons. Pressing either of these buttons also puts
the instrument into multipoint calibration mode.
•
The CALZ button is used to initiate a calibration of the zero point.
•
The CALS button is used to calibrate the span point of the analyzer. It is
recommended that this span calibration is performed at 80% of full scale of the
analyzer's currently selected reporting range.
Because of their critical importance and complexity, calibration operations are described
in detail in other sections of the manual:
•
Section 9 details basic calibration and calibration check operations.
•
Section 0 provides references for performing an EPA protocol calibration.
To avoid inadvertent adjustments to critical settings, activate calibration
security by enabling password protection in the SETUP – PASS menu
(5.5).
The SETUP mode is used to configure the analyzer's hardware and software features,
perform diagnostic procedures, gather information on the instrument's performance and
configure or access data from the internal data acquisition system (DAS). For a visual
representation of the software menu trees, refer to Appendix A. Setup Mode is divided
between Primary and Secondary Setup menus and can be protected through password
security.
Setup Mode can be protected by password security through the SETUP>PASS menu
(Section 5.5) to prevent unauthorized or inadvertent configuration adjustments.
I R
MPACT ON EADINGS OR
Overview of Operating Modes
D
ATA
81