Table of Contents
Advertisement
UDB-9000 Universal Deck Box - UDB-9000-M (Portable) and UDB-9000-MR (Rack Mount) Configurations
3
Installation and Setup
This section provides instructions on how to unpack and set up the UDB-9000
Universal Deck Box and make the power, the transducer and the optional
external connections.
Unpacking and Inspection
The UDB-9000 is carefully packed in one or more sealed boxes, depending
on the items ordered. Carefully inspect the boxes for any signs of external
damage and immediately report any damage to Teledyne Benthos and to the
freight carrier. After inspecting the boxes, locate and remove the packing list.
While referring to the packing list, carefully remove the contents of the box,
checking the items against the packing list to verify that all the items on the
list are included. Inspect the items for any physical damage that might have
occurred during shipment. Immediately report any damage to Teledyne
Benthos and to the freight carrier.
Setting up the Deck Box—Portable
Configuration
The portable configuration of the UDB-9000 is designed for deployment
outdoors in open boats in a water spray environment. However, when
charging the batteries, the deck box must be indoors and near a
85–264 VAC, 47–63 Hz power source. For the outline dimensions of the deck
box, refer to Figure 3-1.
Setting up the Deck Box—Rack Mount
Configuration
The rack mount configuration of the UDB-9000 is designed for installation in
a 19-inch rack. The rack must be indoors and near a 85–264 VAC, 47–63 Hz
power source. To install the deck box, first ensure 6U or 10.5 in. (26.7 cm) of
height in the rack is available and there is room behind the rack for
connecting the cables. For the outline dimensions of the deck box, refer to
Figure 3-2. Then mount the deck box front panel to the rack and secure it
using standard 19-inch rack front panel mounting hardware. Leave the back
of the rack open for proper air flow.
3
Installation and Setup
3-1
Unpacking and Inspection
Advertisement
Table of Contents
