Introduction To The Installation Procedure - PerkinElmer aanalyst 200 User Manual

Introduction to the Installation Procedure

Before you start to install your AAnalyst 200 spectrometer, please take time to read through this self-
installation guide and become familiar with the steps involved. Please make sure your laboratory meets all
of the requirements listed in this chapter, before you begin to install the system.
NOTE: A CD-ROM is provided with the spectrometer that contains a video showing the complete installation
procedure. We strongly recommend that you view this video before you attempt to install your
spectrometer.
Summary of the installation procedure
This summary lists the steps you must perform to install the spectrometer.
1. Inspect the shipment.
2. Unpack the spectrometer.
3. Place the spectrometer on the bench.
4. Install the touch screen.
5. Connect the gas hoses.
6. Set up the burner system.
7. Install the burner door.
8. Install the sample tray.
9. Connect the spectrometer to the electrical supply.
10. Perform the post-installation checks.
Tools required for the installation
You will need the following tools during installation of the spectrometer:
• small flat-bladed screwdriver
• two wrenches for gas fittings
AAnalyst 200 User's Guide
5-3