PerkinElmer aanalyst 200 User Manual page 137

3. Slide the lamp carefully into the lamp holder until it butts up against the end stop inside the holder.
4. Connect the lamp cable to an EDL 1 port on the E-Box. Align the lamp.
Installing EDLs in the turret version
NOTE: EDLs may only be installed in positions 1 and 2 of the turret. Refer to Figure 6-15 for the assigned lamp
numbers on the turret (mount).
1. Open the lamp door.
2. Insert the coding plug over the receptacle on the lamp holder.
NOTE: Do not use coding plug for uncoded EDLs.
3. Slide the lamp carefully into the lamp holder until it butts up against the end stop inside the holder.
4. Depending on the lamp position of the turret, connect the lamp cable to the corresponding EDL port
on the E-Box. Align the lamp.
NOTE: Example: If the EDL lamp is installed in position 1 of the turret, connect the EDL cable to the EDL 1 port
on the E-Box.
Figure 6- 12 Assembling an EDL
AAnalyst 200 User's Guide
6-23