Connecting To The Electrical Supply - PerkinElmer aanalyst 200 User Manual

Connecting to the Electrical Supply

After you have completed the installation procedures described previously, connect the spectrometer to
the electrical supply.
1. Check the line cord provided with the spectrometer to make sure that it is fitted with the correct plug
for your location. If the plug is not correct, contact your local PerkinElmer office for advice.
2. Make sure that the On/Off switch on the spectrometer's E-Box (behind the lamp door) is in the Off
position (depressed).
3. Pass line cord receptacle underneath through the slot at the bottom of the lamp compartment.
4. Insert the line cord receptacle into the line power input module on the E-Box.
5. Insert the line cord plug into a suitable electrical outlet.
6. Do not switch on the spectrometer yet.
The correct procedure for powering up the spectrometer is described in Chapter 6, Operation of the
Instrument.
AAnalyst 200 User's Guide
5-23