PerkinElmer aanalyst 200 User Manual page 186

Touch Screens
Diagnostics
Recommended
Conditions
Network
Calibrate Stylus
Print Method
Service
Download
Set Date and Time
Regional Setting
Startup
Optical position
7-28
This button displays the diagnostic dialog, used to make sure that
your instrument and its accessories have been installed properly and
are functioning properly.
This button displays the Recommended Conditions dialog, which
shows recommended analytical conditions for determining the active
element.
The data tab displays the recommended setup and diagnostic
parameters of wavelength, slit width, relative noise, characteristic
concentration, sensitivity check, and linear to mg/L.
The remark tab displays special conditions about the element that
you are determining.
To view a different element for recommended conditions, the
element in lamp page must be changed.
This button displays the Network dialog, that is use to setup a
network connection between the instrument and a stand-alone or a
network computer. Once a network connection is established, all the
analyses result data will automatically be saved.
Touch this button to run a system utility to recalibrate the touch
screen if the screens are not responding properly to your touch.
Touch this button to print the current active method.
This button is to be used by service engineers.
This button is to be used to upgrade software.
Touch this button to set time zone, daylight saving, date, and time.
Touch this button to format date and time display.
Touch this button to change technique.
Touch this button to show a plot of the most recent wavelength
peaking operation for diagnostic purposes.