PerkinElmer aanalyst 200 User Manual page 302

Maintenance
Figure 9- 22 Adjusting the position of the cell-holder bracket.
3. Tighten the four clamp-adjusting screws.
Replacing or Installing the MHS-15 Quartz Cell onto the Holder
After installing the cell holder, install the quartz cell as follows:
1. Rotate the cell holder bracket to the "up" position.
2. Place the quartz cell in the cell holder as shown in the next figure.
Be certain that the transfer hose cannot become pinched or kinked in any
way. A restriction in the hose may lead to a pressure build-up in the system
which can cause an explosion.
WARNING
9-58