MHS-15 Mercury/Hydride System Maintenance
Refer to the MHS-15 User's Guide (0993-5288) for maintenance details.
Replacing or Installing the MHS-15 Quartz Cell Holder
This section describes how to install the quartz cell holder (B300-0350) onto the burner head. The
following section describes how to then install the quartz cell. the flame (if lit) and allow
adequate time for the burner head to cool.
1. Make sure the two adjusting screws in each clamp are loose. Place the securing clamps of
the cell holder bracket over the ends of the burner head.
Figure 9- 21 Mounting the quartz cell-holder onto the burner head (rear view).
2. Refer to the next figure and align the "V" in the cell holder with the slot in the burner head.
AAnalyst 200 User's Guide
9-57