Flame Page - PerkinElmer aanalyst 200 User Manual

Flame page

You use this page to select the oxidant and other flame parameters, and to ignite the flame. You
also use this page during optimization of the burner system and to view continuous graphical
absorbance display.
To switch oxidant type
1. Shut off the flame and wait until the burner head cools down.
2. To remove and install the burner head refer to chapter 9, Maintenance.
3. On the Flame page, touch the Oxidant entry field box. Select the oxidant type from the
Oxidant dialog.
NOTE: If an air burner head is installed, the Nitrous oxide option is automatically grayed out.
Screen 7- 6 Flame Page
Screen 7- 7 Oxidant dialog
AAnalyst 200 User's Guide
7-11