Stp Point-To-Point - Huawei Quidway S2000 Series Command Manual

Command Manual - STP
Quidway S2000 Series Ethernet Switches
View
System view
Parameter
stp: Specifies to run RSTP in STP compatible mode.
rstp: Specifies to run RSTP in RSTP mode.
Description
Using stp mode command, you can configure the RSTP running mode. Using undo
stp mode command, you can restore the default RSTP running mode.
By default, the value is rstp.
This command can be used for specifying the current Ethernet switch to run the RSTP
in RSTP mode or in STP compatible mode.
For the related command, see stp, stp mcheck.
Example
# Set RSTP to work in STP compatible mode.
[Quidway] stp mode stp

1.1.10 stp point-to-point

Syntax
stp point-to-point { force-true | force-false | auto }
undo stp point-to-point
View
Ethernet port view
Parameter
force-true: Indicates that the link to the current Ethernet port is point-to-point link.
force-false: Indicates that the link to the current Ethernet port is not point-to-point link.
auto: Specifies to check if the link to the Ethernet port is point-to-point link or not
automatically.
Description
Using stp point-to-point command, you can configure the link to the current Ethernet
port as point-to-point link or not point-to-point link. Using undo stp point-to-point
command, you can restore the default status of the link, that is, RSTP is responsible
for checking whether the link to the Ethernet port is point-to-point link or not.
Chapter 1 RSTP Configuration Commands
1-8