Configuration Of Ip Address, Subnet Mask And Gateway Address; Figure 5. Ip Setup Page - Allied Telesis AT-GS950/8 User Manual

Chapter 2: Basic Switch Configuration

Configuration of IP Address, Subnet Mask and Gateway Address

26
This procedure explains how to change the IP address, subnet mask, and
gateway address of the switch. Before performing the procedure, note the
following:
A gateway address is only required if you want to remotely

manage the device from a management station that is separated
from the switch by a router.
To configure the switch to automatically obtain its IP configuration

from a DHCP server on your network, go to "DHCP Client
Configuration" on page 35.
To change the switch's IP configuration, perform the following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select IP Setup.
The IP Setup Page is displayed. See Figure 5.
3. Change the IP configuration parameters by observing or entering new
information in the following fields:
System MAC Address - This parameter displays the MAC
address of the switch. You cannot change this parameter.
System IP Address - Displays the current IP address of the
switch. To change the IP address, enter a new IP address.
When DHCP is enabled, you cannot change this parameter.
System Subnet Mask - Displays the current subnet mask of the
switch. To change the subnet mask, enter a new subnet mask.
When DHCP is enabled, you cannot change this parameter.

Figure 5. IP Setup Page