Peer Enable (Bgp View) - 3Com S7906E Command Reference Manual

ip-address: IP address of a peer.
hop-count: Maximum hop count, in the range 1 to 255. The default is 64.
Description
Use the peer ebgp-max-hop command to allow establishing an EBGP connection with a peer/peer
group that is on an indirectly connected network.
Use the undo peer ebgp-max-hop command to restore the default.
By default, this feature is disabled.
You can use the argument hop-count to specify the maximum route hop count of the EBGP connection.
Examples
# In BGP view, allow establishing the EBGP connection with the peer group test that is on an indirectly
connected network.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test ebgp-max-hop
# In BGP-VPN instance view, allow establishing the EBGP connection with the peer group test that is
on an indirectly connected network (the VPN has been created).
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-vpn1] peer test ebgp-max-hop

peer enable (BGP view)

Syntax
peer ip-address enable
undo peer ip-address enable
View
BGP view
Default Level
2: System level
Parameters
ip-address: IP address of a peer.
Description
Use the peer enable command to enable the specified peer.
Use the undo peer enable command to disable the specified peer.
By default, the BGP peer is enabled.
If a peer is disabled, the router will not exchange routing information with the peer.
1-48