Network; Peer - 3Com Switch 4500 Family Manual

network

Syntax
network network-address
undo network network-address
View
RIP view
Parameters
network-address: Network/IP address of an interface, in dotted decimal notation.
Description
Use the network command to enable RIP on an interface attached to the specified network segment.
Use the undo network command to disable RIP on the interface attached to the specified network
segment.
RIP runs only on the interface attached to the specified network. For an interface not on the specified
network, RIP neither receives/sends routes on it nor forwards interface route through it. Therefore, you
need to specify the network after enabling RIP to validate RIP on a specific interface.
By default, RIP is disabled on all interfaces.
The differences between the network and rip work commands are as follows:
The network command enables RIP on an interface attached to the specified network segment.
The rip work command enables an interface to receive and send RIP packets.
Related commands: rip work.
Examples
# Enable RIP on the interface with the network address 129.102.0.0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] rip
[Sysname-rip] network 129.102.0.0

peer

Syntax
peer ip-address
undo peer ip-address
View
RIP view
Parameters
ip-address: IP address of the interface receiving RIP packets in the unicast mode on the neighbor router,
in dotted decimal notation.
3-9